Installation Instructions

 

Installation Instructions 

 

  1. Remove existing leather earpad from headset. As well as the earpad from the Adapter plate. 
  2. Before removing Red 3M protective film from tape, Line up the Center hole and find the Corresponding holes that line up with your particular headset (This is in case your headset needs to be serviced in the future.),Wider part of red tape is the Top.   

  3. Once you know which 4 holes line up with your headset, Peel back the Red Protective film on the 3M Tape. 
     
  4. Carefully line up center hole first, then rotate to line up the corresponding 4 holes, Once in position press the Adapter down onto the headset. 
     
  5. Squeeze the adapter and the headset together firmly for 20-30 seconds. 
     
  6. Grab the Earpad that was included with your adapter plate as well as the Earpad Installation Tool. 
     
  7. Partially slide the new earpad onto the top part of the adapter and using your off-hand, hold the new earpad in place so the backing cannot slide off. 
     
  8. Use the included Earpad Installation Tool, starting from the 11 O’clock position, using the pointed end to drag the edge Counter-Clockwise until the backing pad is fully surrounding the Adapter plate. 
     
  9. The Earpads are slightly pliable so if the Installation tool is not working for you, It is possible to use your finger and Stretch the Earpad into place.